Adblue emulator installation manual for DAF LF 45 EURO 5 (CUMMINS)
Step 1: Connecting Can Smart emulator
1.1 First, please find the ABS module located behind the front passenger side panel and connect the following wires to the wires coming into the black plug. (please see photo below, plug circled in red)
1.2 Can Smart adblue emulator wire colours:
| № | Color | Signal | Function |
| 1 | Red | POWER [+24 V] | Positive [after ignition] |
| 2 | Brown | GROUND [-] | Negative |
| 3 | Yellow | CAN High | CAN Line High |
| 4 | Green | CAN Low | CAN Line Low |
Step 2: Removing fuses
2.1 Please locate the fuse box and remove three fuses as shown in the picture below. This will disable SCR system and Nox sensor entirely.
Step 3: Completing installation
3.1 To complete the installation, please check the led light on the emulator, this should be done with ignition on or with vehicle running. If the light is blinking slowly, approximately once per second, the emulator is fully operational and the installation is complete.
Error codes:
If there were SCR related faults prior to installing he emulator, normally these errors will go away without the need to erase them with diagnostic tool. However, if the vehicle had active Nox fault, which was there for some time, it will stay there after installing the emulator. If Nox fault stays, the vehicle must be driven under load (with emulator fully installed) It normally takes 20 – 50 miles of driving under load after installing the emulator for active Nox faults to go away. For active Nox fault to be cleared, ECU need to run test and register the correct signals sent by the emulator so that it thinks the fault was repaired. Such test are only run once exhaust system reaches required temperature, hence the vehicle needs to be driven under load for its exhaust to reach such temperature. Active Nox faults can also be cleared instantly with dealer level diagnostic tool. If you do not have the access to such tools, the only other way is to drive the vehicle under load as explained above.
SPECIFICATION:
Can Smart emulator will emulate the following components: NOx sensor SCR module Adblue pressure sensor Adblue pump Adblue pump heater Please note, Can Smart emulator does not emulate Adblue tank level sensor. It must be in working condition for the emulator to perform 100% Your adblue level will stay the same as before installing the emulator, whatever you have in the tank – that is what the gauge will be showing. Adblue temperature sensor must also be in working condition, as data from this sensor is sent directly to the vehicle’s ECU and therefore it is impossible to emulate via the adblue emulator.